Dang! Aggressive offset destroyed bumper bracket, anyone else deal w/ this?
#17
In case this helps anyone, here is what I ended up doing:
1: Grind/cut the remains of the braket off
2. De-burr, paint sheet metal
3. There is enough material left behind the original bolt bracket position the sink a good sheet metal screw through the bottom and up into the sheet metal: pre-drill and sink screw.
Here is a pic, panel alignment is now perfect and no rubbing:
1: Grind/cut the remains of the braket off
2. De-burr, paint sheet metal
3. There is enough material left behind the original bolt bracket position the sink a good sheet metal screw through the bottom and up into the sheet metal: pre-drill and sink screw.
Here is a pic, panel alignment is now perfect and no rubbing:
Thread
Thread Starter
Forum
Replies
Last Post
Striderx88
Private Classifieds
13
10-10-2015 11:42 PM