So I used wheel offset calculator and calculated the offset from the Volk Racing Gt30 wheels that everybody has and compared to the stock wheels they stick out 26mm in the Rear and 22mm in the front. Now that is just the wheel itself, you would get different looks, with different tires. SO I put on Ichiba Type II 25mm and 20mm for the Rear and Front. But I am getting vibration around 60-70, has anybody had same issues and came up with a solution?

I have the spacers torque at 90 and my wheels at 80, and I have hub centric rings, they only thing I could think of is that the hub ring lip that holds the wheel is not as long as the stock hub ring.

Any ideas? Please I need help, I tried taking them off and I cannot stand the look at this point.

So either spacer or set of new wheels its a must.

 

I had vibration issues with Ichiba 10mm spacers on my G37, the type where you replace the OEM studs with longer ones.
I double checked everything and finally took them off.
I used H&R spacers on my FX35 and had no vibration at all.

 

Something may not be sitting 100% right. You may just have to take them off and do it over again and make sure everything is aligned right and sitting flush.

 

This is why i'm not down with spacers. Hope you get your issue resolved.