Enough chatter, please.

 

Oh c'mon aren't we allowed to have a little fun in a thread that has been dead for 6 months?

 

If you're looking for fun, use the off-topic forum. This thread is for OE wheel info and there's already too much garbage in it. Maybe I should cull all that out and lock the thread.

 

Dude, lighten up. It's a joke. If you have to be that serious go ahead and "cull all that out" and lock the thread. Not much new information on OEM wheels and tires is going to be presented on a car that was discontinued years ago.

 

And jokes go in off-topic. Part of my job as an admin is to reduce the chaos of this board to help make it easier to find stuff. If that means being the occasional kill-joy, so be it.

 

I'm not here to tell you how to do your job, but if you can't joke in any thread and you take humor and fun out of the forum then no one posts and the forum dies. This forum does not see much traffic as it is because it is for a car that no longer exists. If you post on an old thread it comes back to life and either goes to the top of the list or reminds all the subscribers to the thread that it exists. Don't take like too seriously, you'll never get out alive.

 

So I have a g37s and I got some wheels from Fitment Industries they have an offset of 40mm and the front wheels dont fit right, they scrape the caliper since the sport trim of the car has bigger brakes, I need to get some spacers or adapters to make them fit right since I dont plan on sending them back and I like the new wheels too much to sell them, I need help though since I dont know which I should get and how I should put them on since I dont know if they make adapters that are 3mm, and also if they would require me to cut down the screws (i have the tuners bolts they sell you on Fitment Industries)

 

If 3mm is enough to get you enough caliper clearance here's a set~
https://www.titanwheelaccessories.co...axima-66-1-hub

Not sure what you mean about cutting down the screws, if you mean shortening the wheel studs, that won't be necessary w/ those 3mm spacers.

5mm spacers MAY require longer studs, anything over 5mm WILL need extended studs.

 

I'm closing this thread unless new O.E. info comes to light. Too many post in here about non-O.E. wheels.