tapout19

My Vdc light , abs and slip light are all stuck on. I dont know whats goin on with that but the car is running normal.. Anyone have this problem or can anyone gimme some ideas of whats up..much help needed...thanks

37drift

Check your brake fluid level. Had the same thing happen to me and I freaked out. Turns out the levels were a little low due to the cold weather.

If that doesn't fix it, take a walk around all four corners of your car and rub your finger along the bottom of your caliper checking for leaking fluid. I also had a leaky rear caliper seal. (Ruined the paint on my wheel)

Hope that helps.

PJ

MaxToTheG37

iTrader: (3)

Mine did that on the dyno... i just reset my ECU and it was fine...

Kidcane

iTrader: (7)

Yeah I got it on the dyno too or if I take my VDC off and do some drifting/doughnuts they all light up.

Achilles

what they said or you can just take it in, get ur loaner and be on ur way!!!!!!!!

KAHBOOM

iTrader: (4)

Do you have aftermarket wheels on?

tapout19

the car is slammed on 20s high flo cats, stillen gen 3. stillen exhaust. carbon hood and trunk n i have previously reset the ecu. checked thebreak fluid and thats all good. I just dont want to bring it into infiniti bc they will just try to pin it on one of my aftermarket parts when I know its not. I had my boy run codes on it and it came up fine so Im still lost here..but thanks for all the help

wtf09876

i had all the lights turn on after i turned off the traction control and did some doughnuts i freaked out but after i turned the car off and then started it up again all was fine.

NJlakeshoreG

iTrader: (1)

how many miles??? u might need brakes bro

samurai_skyline

Had this happen to me too.. Dealer said it was a brake pedal sensor. They reset it and it has been fine for 3000+ miles..