Show off your Sedans!
Registered Member
The following users liked this post:
markyo0o (06-22-2018)
Registered User
Join Date: Nov 2016
Location: Charlotte, NC from OH thru VA
Posts: 739
Received 71 Likes
on
65 Posts
Definitely going to install the Tein Coilovers I have for it. I'm not going to "slam" it but I plan to get rid of the gap. It' looks like the lip of the wheel would tuck if I needed it to so I want as much tire as I can get for on a 20x9 without rubbing.
Registered User
iTrader: (1)
Movin On!
iTrader: (13)
I'm running 9.5 +38 and the wheels' edge isn't a problem there, a wider 265 will be close to the angled fender edge under heavy compression, it may clear ok but wanted to give you a heads up as you might need to flat-roll that fender edge to get full clearance but
The following users liked this post:
r2dmax (06-25-2018)
Somewhere around 25.5 inches. I only dropped it to that height to just see how it would sit. Imo, it’s not practical to drive it that low as the LCA is almost kissing the floor and if I were to hit a dip too fast, I will smash it bad. 26 inches from floor to fender is ideal for daily. I can make it over speed bumps with little to no scrape. If it’s a fat speed bump, I will take it a bit angled. Driveways are a different story.
Registered User
iTrader: (1)
Somewhere around 25.5 inches. I only dropped it to that height to just see how it would sit. Imo, it’s not practical to drive it that low as the LCA is almost kissing the floor and if I were to hit a dip too fast, I will smash it bad. 26 inches from floor to fender is ideal for daily. I can make it over speed bumps with little to no scrape. If it’s a fat speed bump, I will take it a bit angled. Driveways are a different story.
The following 3 users liked this post by sergey63780:
Movin On!
iTrader: (13)
Very nice look Sergey, great job all around!
Registered Member
Neat pics, what's the license plate mean?
Registered Member
Way behind on looking through this sub. Just got a G37X a month ago and I've never done mods on cars before but this is the perfect car to do it on. I want a very clean look and love the way your's looks. What's the front spoiler you have? Also what exhaust are you running on this?
Registered User
Finally got my wheels on. Rides great little vibration at high speeds, noticed i need hub rings. Going to Drop the front waaay more tomorrow, then alignment next week
Last edited by stiizy; 07-02-2018 at 09:21 AM.