Rochester's new G
#1516
Administrator
Thread Starter
iTrader: (9)
LOL, you guys are tripping over one another with the same problem.
I'm using a HPS coupler at the TB. Specifically a 4" x 70mm coupler that I cut in half, one for each side.
Here's an old pic. Does mine look thicker than yours? Do you get that question a lot?
I'm using a HPS coupler at the TB. Specifically a 4" x 70mm coupler that I cut in half, one for each side.
Here's an old pic. Does mine look thicker than yours? Do you get that question a lot?
#1522
Premier Member
iTrader: (5)
) from GTM, so I can't just swap them out for another type.
The following users liked this post:
hexotic (02-28-2017)
#1526
Registered Member
Not surprised to see this kind of stuff in this guy's thread...
#1529
Registered Member
iTrader: (7)
Comedic gold here on this page.
Anyway, Rochester- did you end up getting a Skyline badge for your trunk? The place with the kick plates also has Nissan badges for the trunk and front grill. (I know you are planning to keep the Fuji, but I am such a damn perfectionist.) I am just waiting to hear back if they have any Nissan or Skyline floor mats or a horn cover for the steering wheel.
Anyway, Rochester- did you end up getting a Skyline badge for your trunk? The place with the kick plates also has Nissan badges for the trunk and front grill. (I know you are planning to keep the Fuji, but I am such a damn perfectionist.) I am just waiting to hear back if they have any Nissan or Skyline floor mats or a horn cover for the steering wheel.
#1530
Administrator
Thread Starter
iTrader: (9)
Haven't done anything yet.