zeeshanmalik08

Is this how your stock G37s exhaust's rear end look like? (Just the design) This is how my car's exhaust looks like and I am pretty sure it is not aftermarket (my car is GCC Spec though if that makes any difference?)




I am asking because I want to install Beluga axleback (picture below) and I don't know how it would fit on this exhaust design.

blnewt

iTrader: (13)

As long as you have the OEM Y and mid pipes you'll be fine, here's a pick of OEM setup

zeeshanmalik08

Thanks! Yes that's exactly how the exhaust looks like. But where exactly will the axleback be attached because behind the rear muffler there is single bolted connection with the Y pipe? Or did I get it wrong...

Presto

the oem exhaust posted above will break apart into 3 pieces. starting from the front the Y shaped pipe, the piece following it and finally the axleback part (the bolts cannot be seen as the pic is taken from rear of exhaust). I am guessing the beluga one replaces the axleback part. just make sure the beluga one is for a g37.

Landshark

no, your exhaust does NOT look like that - here is your exhaust pic from the other thread:




you have some sort of CATBACK exhaust, where the rear AND mid pipes have been replaced. the Beluga axleback will not attach to this.