Ive got my list of mods going and iwas just wondering if the camber kit was really needed for only an inch drop.

 

I'm assuming it's not for your CBR :P

You should be good with an alignment after the springs settle in, no camber kit here.

Welcome on board btw, what mods you got in mind?

 

I went the Eibach route and did install a rear kit....

 

+1 just to be safe...

 

It depends on your liking... Some people really like the Neg camber look... I would get a camber kit to be on the safe side...

 

Thanks guys, i just got my g. Ive got the wheels headn out to the powdercoaters next week, tryn to get ahold of the guy for the iron man headlights, thinkn about the stillen gen 3, fast intentions or tanabe exhaust, i could really go on and on after reading all of your mods.

 

Iron-man you want to PM IGOR..@180customs... If your east coast...

UCLA bruin...If your west coast..

FI without a doubt over Tanabe...Tanabe is not a full catback so it will really just make some noise and not power..

Stillen you have to cut through your plastics, go for Injen..

 

with my eibach drop, im running -1 front, -1.5 rear camber with 0 toe without any camber kits.