stillen gen 3 long tube intake vibrating probs
#17
I agree! My intake was also rubbing on to the AC tubing which I ended up replacing. Pain in the butt and an unnecessary expense.
#18
Premier Member
I had the same problem.....all I did was install a small square of double stick velcro. This way the velcro is attached to both the strut tower and the back side of the intake pipe. You can also use a "silicone dot" from home depot....basically a small cicrle of silicone used as a door bumper in a cabinet. Either work and are both inexpensive solutions
#19
Just a piece of foam tape is all you need. Any Lowe's/Home Depot should have it. The fitment is mediocre at best but it is the best intake for our cars and generates some serious hp you can feel.
#22
Super Moderator
iTrader: (2)
I used 2 layers of electrical tape and then ran strips of 3M like a DIY I saw. No rubbing / vibration at all. Even holding up against the swing in temps here in MD. Also worth noting, I popped off my intakes to clean my TBs and there was quite a bit of rubbing as I moved the CAI out of position and my anti vibrating measures have held up
Thread
Thread Starter
Forum
Replies
Last Post