Help Berk HFC noise
#1
Berk HFC noise
I got my Berk HFCs installed this week (at my Infiniti dealership!) and have driven about 500 miles on them. I'm now hearing a loud rattling noise (no SES though) sometimes under idle or light acceleration and under hard acceleration. It sounds a little like there are marbles or rocks inside rattling around inside. Has anyone else experienced this or know what to do about it?
#4
You might want to inspect that the exhaust pipes are properly fitted and that there are no nuts stuck inside any heatsheilds.
Try banging around the exhaust pipe with a rubber hammer to see where the culprit is.
Try banging around the exhaust pipe with a rubber hammer to see where the culprit is.
#6
<object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed></object>
#7
My stock exhaust went bad and started rattling after I got my HFC's. The extra flow pushed it over the edge, does it sound anything like this?
<object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed></object>
<object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/QnBnKdwHPA4&hl=en&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed></object>
Trending Topics
#8
they might have loosened some of the heatshield during install. Go out and kick one of you tail pipes and see if you hear a rattel with the car off. I thought my failed muffler noise was goming from up around the y-pipe when i first started getting it. But then i heard a rattel one day when i was getting out and clossed my door. I did it again and founr it was coming from the muffler then when i shook the muffler it was100%. could hear it tinking around.
#9
Its the exhaust. I had my FI HFC installed with stock exhaust and it was working fine for about 1k miles. Afterward, the exhaust started to rattle between 30-50mph for 15 minutes after a cold start. Switched to FI exhaust and my problem was solved.
#10
its the rasp from HFC's i should be normal. it should be loud when your car is cold but once its warmed up it should lower by alot. and with stock exhaust u will hear it more. my berks do the same but with the FI catback its better. dont worry, its most likely the rasp every test pipe and HFCs produce.
#12
I have Tanabe exhaust that was installed before HFC. Its not coming from the tailpipes or mufflers. I listened as close as I could today without putting it on a lift. It's like peterbanks' noise. It's the HFCs or the part of the Y pipe right behind it as best I can tell. I've gotten almost 1K miles this past week and I notice it mostly at idle. I'll have to check it out more closely when I get home Thursday.