VR30 trans swap 2013 Sedan
#33
With VQ 7-speed
With VR 7-speed (Don't mind the fluid, I had just popped it out and back in so it dribbled a little). Note the cutout to the transmission mounting brace to accommodate the new transmission. The cutout does not seem to affect the sturdiness of the mount. I also had to cut/shorten the shifter linkage as you can see from the photo where I cut and put a blob of weld (a ****ty one) on the linkage.
#35
With VQ 7-speed
With VR 7-speed (Don't mind the fluid, I had just popped it out and back in so it dribbled a little). Note the cutout to the transmission mounting brace to accommodate the new transmission. The cutout does not seem to affect the sturdiness of the mount. I also had to cut/shorten the shifter linkage as you can see from the photo where I cut and put a blob of weld (a ****ty one) on the linkage.
yea, this is mine
#36
How do you like the CF driveshaft? Do you notice quicker revving?
I see some space there, if that measures half an inch then it *might* work or might not. Maybe take it to a driveline shop to shorten it for you, might be cheaper than getting a new one.
I see some space there, if that measures half an inch then it *might* work or might not. Maybe take it to a driveline shop to shorten it for you, might be cheaper than getting a new one.
#37
I love it. Huge difference from the factory driveshaft. Unfortunately I was told that it can't be done. So, I have to get an aluminum one
The following users liked this post:
spoolin03 (12-08-2021)
#38
Moderador
Both these pictures look great to me. What kind of DS are they?
#41
Thread
Thread Starter
Forum
Replies
Last Post
slotterjordan
Engine, Drivetrain & Forced-Induction
12
07-07-2016 12:37 PM
Ali6767
Engine, Drivetrain & Forced-Induction
5
06-30-2015 05:18 PM