What did you do to your Sedan today?
The following users liked this post:
iCrap (07-31-2017)
#3379
Administrator
iTrader: (9)
#3383
Administrator
iTrader: (9)
The following users liked this post:
mdigiorgio35 (08-01-2017)
#3384
Registered Member
iTrader: (4)
Hey dude, props to you for doing it yourself. There is stuff on my car that I've done myself that's not 100% perfect. But, the fact that I tackled the job myself makes it worth it and you feel a sense of accomplishment. And, I can always go back and re-do it with the knowledge I have gained.
Plus, it's meant to be a budget setup. I'm sure you saved like $70 + opposed to going to a muffler shop and having it done. And, the exhaust probably sounds equivalent to more expensive catback systems out there.
The following users liked this post:
iCrap (07-31-2017)
#3385
Registered Member
iTrader: (8)
Hey dude, props to you for doing it yourself. There is stuff on my car that I've done myself that's not 100% perfect. But, the fact that I tackled the job myself makes it worth it and you feel a sense of accomplishment. And, I can always go back and re-do it with the knowledge I have gained.
Plus, it's meant to be a budget setup. I'm sure you saved like $70 + opposed to going to a muffler shop and having it done. And, the exhaust probably sounds equivalent to more expensive catback systems out there.
Plus, it's meant to be a budget setup. I'm sure you saved like $70 + opposed to going to a muffler shop and having it done. And, the exhaust probably sounds equivalent to more expensive catback systems out there.
Yea, exactly. I saved some $$ and learned something in the process. Dosen't look great but it works. Not like i'll ever see it anyways lol.
#3386
Administrator
iTrader: (9)
Here's what I did today... installed my new P2M aluminum clamp for the upper radiator hose. Not a whole lot of skills needed here, LOL.
#3390
Thought it was worth mentioning that in order to push the lower control arms down far enough to remove the OEM spring, I had to disconnect my Invidia muffler on each side. Otherwise the lower control arm was butting up against the flanges.
Last edited by G37_4DR; 08-02-2017 at 12:44 AM.