GTHaus exhaust
#2
Movin On!
iTrader: (13)
Check Natalies' thread and you might shoot her a PM for the vendor she used. She's got sound clips on the thread too. IMO it's awesome but really depends how bad-to-the-bone you wanna be
https://www.myg37.com/forums/picture...g37-sedan.html
The following users liked this post:
sask83 (12-18-2013)
#3
Registered Member
iTrader: (2)
I love the meisterschaft exhaust it has sucha unique sound to it. in the low rpms it gives a deep throaty tone but higher rpms it goes more higher pitched and its really loud but if you want the mufflers alone you should be fine its not loud at all. here's mine before I put the mid and y pipe
#5
Registered User
iTrader: (1)
I love the meisterschaft exhaust it has sucha unique sound to it. in the low rpms it gives a deep throaty tone but higher rpms it goes more higher pitched and its really loud but if you want the mufflers alone you should be fine its not loud at all. here's mine before I put the mid and y pipe
The following users liked this post:
sask83 (12-18-2013)
The following users liked this post:
kdawg8526 (12-23-2013)
#10
I received my exhaust the other day and it looks great and cant wait to install it. However I did notice it didnt have any flanges to bolt to the existing pipe, but it did come with clamps. What did you guys do, did you use the clamps or did you weld it to the mid pipe?
#11
One of the best if not the best. IMHO you won't need hfc's of any kind with this, other wise youll sound like that @sshole with srt4 down my block freeking uses the car to make a phone call or text every 2 minutes...... Sorry had to let that out
Again the best axhaust for us imo
Again the best axhaust for us imo
#12
Registered Member
iTrader: (2)
the axle back fit really loose over the stock midpipe because of the pipe diameter difference so what I did was just put some screws thru the midpipe to hold it in place.
and if I were you id order the mid-pipe too or do a custom piping. because once you start clamping the axle back onto the stock mid-pipe it kinda deforms the metal and I had issues of it not sliding onto the new mid-pipe properly when I finally got it. it still doesn't fit on completely its a tiny bit off.
I hope that made sense I wish the exhaust would've been like the coupe where its bolt on instead of the clamp on type
Last edited by kdawg8526; 01-29-2014 at 12:19 PM.
The following users liked this post:
sask83 (01-29-2014)
Thread
Thread Starter
Forum
Replies
Last Post
4DRZ
Engine, Intake and Exhaust
12
05-18-2017 11:25 AM