Q50 front
#16
Registered Member
I agree, the Q grill is too big. I think blending the bottom of the Q with the top of the G from the OP looks fantastic. It looks like it belongs that way on our cars.
#27
Yep the upper will be from a G37S Coupe bumper and the lower will be from the Q50S bumper design Outcast Garage already has. We're chopping the 2 bumpers up, fusing them together, perfecting the fitment and look, then we will build a mold from which our bumpers will be made from.
Right now the bumper cost (just the bumper) is 650-700. The additional trim pieces (grille, fogs, bezels, lip, etc...) will be additional. But currently we're in line to price it lower than buying an IPL w/ fogs from Infiniti. The cost is reflected on the price that it WILL BE a Poly bumper, not a Fiberglass.
Right now the bumper cost (just the bumper) is 650-700. The additional trim pieces (grille, fogs, bezels, lip, etc...) will be additional. But currently we're in line to price it lower than buying an IPL w/ fogs from Infiniti. The cost is reflected on the price that it WILL BE a Poly bumper, not a Fiberglass.
#28
#29
Wasn't saying the quality was going to be bad; just saying I'm in a position to speak on it
#30
I know I'm just re-insuring everyone this is going to be as close to an oem fit as possible. I don't post a lot in the forums, so I get a lot of these guys probably don't know me just want people to know this is going to be a top quality product.
The only issue I foresee is the under splash trim might not fit exactly. But this was an issue with my F sport bumper. To solve we cut the splash trim in half, mounted the rear part of the trim like oem, and we just moved the front portion up a bit. This leaves the brace exposed, but covers all gaps to keep as much water out as possible.
The only issue I foresee is the under splash trim might not fit exactly. But this was an issue with my F sport bumper. To solve we cut the splash trim in half, mounted the rear part of the trim like oem, and we just moved the front portion up a bit. This leaves the brace exposed, but covers all gaps to keep as much water out as possible.
Last edited by Numonik; 04-04-2016 at 11:22 AM.