Dillybar12

Looking for a DIY for installation of a rear Diffsuer and front splitter.

Also, I don't know how to go about wrapping these parts... Should I wrap on the car or wrap the pieces off the car?

Thanks

kennyz424

iTrader: (147)

Which brand splitter and diffuser did you buy? I'll try to find you some DIY install instructions and also I'd highly consider doing the vinyl wrap before you install them. It's much much easier that way. Trust me take it first hand from a guy who just finished vinyl wrapping his entire cars exterior and interior lol

Dillybar12

I just don't want to ruin the wrap if I have to drill.

Diffsuer is a auto kits x and the splitter is the IPL splitter from Stillen

kennyz424

iTrader: (147)

I drilled into mine, both my front and side splitters, and didn't ruin the vinyl wrap at all

beng37s

iTrader: (1)

+1 on this. Also don't be afraid to be pretty liberal with the screws/bolts you use. These things take a lot of wind especially at higher speeds and there's plenty of people who have had theirs literally fly off.

Dillybar12

Do either of you guys know where I can find a DIY on both of these products? Really dont want to pay the labor for something I can do on my own...

Thanks

beng37s

iTrader: (1)

Not sure. I do know that there are not pre driller or cut holes in the splitter so each install varies and there's no written in stone way to do it. It can definitely be done on your own with a drill and very sturdy bolts.

G37sGraphite

iTrader: (9)

I just installed the Diffuser AK V1 and Stillen Splitter but my splitter required some modification yours should just bolt on. However, you will need to drill into your bumper and and dont use the crappy screws they give you. Get some bolts and nuts. Plus honestly you have to take the front bumper off...no way you can do a good job without taking the bumper off. The Diffuser is easy....I put extra double stick tape below the areas that they already had. Mine attached to the 3 OEM holes on the car I put in screws some people use the plastic push pins but I put in screws. No drilling needed for the diffuser.

Here is my thread on the stillen splitter.
https://www.myg37.com/forums/g37-cou...rt-bumper.html