Cold Start Vid with Manzo Exhaust
#1
Registered User
Thread Starter
Cold Start Vid with Manzo Exhaust
I've posted a clip of the exhaust while revving, but I haven't yet recorded how it sounds during a cold start. So, here it is!
I didn't want to be too obnoxious (recorded at 8:00 A.M. in my apartment complex), so apologies in advance for the low revs.
Sounds pretty good to me. At times, the noise level/cabin drone can be a bit annoying. Especially on long interstate commutes. I just drove 9 hours and after hour 5 I had to turn up the radio-- I think it was due to the fact that my rear seats were pulled down and the trunk enclosure was open to the cabin.
I'm thinking about getting RHFCs, but that would just increase the noise level, right? Or, reinstall the stock muffler and run RHFs.. decisions, decisions..
I didn't want to be too obnoxious (recorded at 8:00 A.M. in my apartment complex), so apologies in advance for the low revs.
Sounds pretty good to me. At times, the noise level/cabin drone can be a bit annoying. Especially on long interstate commutes. I just drove 9 hours and after hour 5 I had to turn up the radio-- I think it was due to the fact that my rear seats were pulled down and the trunk enclosure was open to the cabin.
I'm thinking about getting RHFCs, but that would just increase the noise level, right? Or, reinstall the stock muffler and run RHFs.. decisions, decisions..
#2
I am going to order the TopSpeed bevel tips exhaust. I believe Manzo and TopSpeed are pretty much the same company.
Not sure if I should do it before or after winter.
Did you get it professionally installed? I don't know how to install it nor do I have the tools for it.
Not sure if I should do it before or after winter.
Did you get it professionally installed? I don't know how to install it nor do I have the tools for it.
#3
Registered User
Thread Starter
Right.. I love the look of the beveled tips. I installed it myself! I've actually done it twice now. I installed it and then removed it after 4 months. Then 5 months later I installed it again . I'm very indecisive. It's not hard at all, just need a socket set. The hardest part is getting the old muffler off of the hangers. I also didn't use a lift, or jacks..
Thread
Thread Starter
Forum
Replies
Last Post
mjnoles1
Wheels & Tires
3
01-04-2016 02:46 PM