IPL bumper fitment issue
#1
Registered User
Thread Starter
IPL bumper fitment issue
I was curious if I was the only one experiencing an issue with the IPL bumper. Mine is not latching at the driver's side top portion near the head light/hood. Has anyone else experienced this issue and if so how did you fix it?
#3
Registered User
Thread Starter
#4
Registered User
iTrader: (1)
Did you put the plastic bracket and the metal piece in the proper place? When you put the bumper back in place make sure you hold it in the middle and put it up evenly across the front end from bottom pushing up, but don't be too rough...it should snap right on as long as bumper is aligned with the headlight
Trending Topics
#10
Registered User
iTrader: (1)
it looks like the bumper is not lined up properly at the headlight. the corner is a bit on top of the light....have put any of the screws yet....if you did, don't...is the other side perfectly flush with the light...there shouldn't be any space in the sharp corner of the light between the bumper and the headlight...
Just place the bumper by pushing the bottom slightly with your legs and guide the top with your hands so the plastic push pins should be lining up perfectly with the holes where the pins go...let know how it goes...
Just place the bumper by pushing the bottom slightly with your legs and guide the top with your hands so the plastic push pins should be lining up perfectly with the holes where the pins go...let know how it goes...
#11
Registered User
Thread Starter
it looks like the bumper is not lined up properly at the headlight. the corner is a bit on top of the light....have put any of the screws yet....if you did, don't...is the other side perfectly flush with the light...there shouldn't be any space in the sharp corner of the light between the bumper and the headlight...
Just place the bumper by pushing the bottom slightly with your legs and guide the top with your hands so the plastic push pins should be lining up perfectly with the holes where the pins go...let know how it goes...
Just place the bumper by pushing the bottom slightly with your legs and guide the top with your hands so the plastic push pins should be lining up perfectly with the holes where the pins go...let know how it goes...