KPTechnologies Shift Lights
12-11-2005, 04:31 PM
#211
Moderator
iTrader: (5)
Join Date: Apr 2005
Location: San Francisco, Bay Area
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Chuck,
Thank you . . . Thank you for your DIY link. It was extremely helpful. This link is a must. It takes all of the install uncertainties out of the equation. Especially, for someone such as myself.
Daniel,
The Window Up mod rocks big time. It installs very cleanly and works to a fault. It is a must mod in my opinion. This is how our cars should have come from Infiniti in the first place. Thanks!
Thank you . . . Thank you for your DIY link. It was extremely helpful. This link is a must. It takes all of the install uncertainties out of the equation. Especially, for someone such as myself.
Daniel,
The Window Up mod rocks big time. It installs very cleanly and works to a fault. It is a must mod in my opinion. This is how our cars should have come from Infiniti in the first place. Thanks!
12-11-2005, 05:02 PM
#212
Guest
Posts: n/a
Originally Posted by andy2434
Chuck,
Thank you . . . Thank you for your DIY link. It was extremely helpful. This link is a must. It takes all of the install uncertainties out of the equation. Especially, for someone such as myself.
Daniel,
The Window Up mod rocks big time. It installs very cleanly and works to a fault. It is a must mod in my opinion. This is how our cars should have come from Infiniti in the first place. Thanks!
Thank you . . . Thank you for your DIY link. It was extremely helpful. This link is a must. It takes all of the install uncertainties out of the equation. Especially, for someone such as myself.
Daniel,
The Window Up mod rocks big time. It installs very cleanly and works to a fault. It is a must mod in my opinion. This is how our cars should have come from Infiniti in the first place. Thanks!
12-11-2005, 06:06 PM
#214
Banned
iTrader: (2)
Join Date: Jan 2004
Location: Ohio
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by klg35
who have installed the shift light on their sedans? need to verify if pin #12(crank sensor/light brown wire) is the same as the coupe........if not, which pin #/color wire is the crank sensor for the sedans, specifically 04 6mts...I'll try to dig this info up in another thread as well............thanks.
According to the 04 sedan service manual the crank wire is brown, but its pin 95. There are three brown wires, just like the sedan. However, the service manual only documented the A/T tranny, so it MAY differ to the 6mt. I don't have any info on the 6mt!
12-11-2005, 07:53 PM
#216
Registered User
Join Date: Feb 2003
Location: Utah
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hey guys, I need some help. I'm looking for someone who has an 2003.5 coupe and has installed the shiftlight. I can't get mine to work. Which wires did you 03.5 owners tap into.
Orange goes to blue/yellow vdc wire
Black goes to vdc black
Yellow goes to black wire w/fuse and to ?
Blue goes to ?
I hooked my black/fuse to the cigarette lighter and I can't find a rpm signal wire. Any help is appreciated.
Orange goes to blue/yellow vdc wire
Black goes to vdc black
Yellow goes to black wire w/fuse and to ?
Blue goes to ?
I hooked my black/fuse to the cigarette lighter and I can't find a rpm signal wire. Any help is appreciated.
12-11-2005, 07:57 PM
#217
FGC Central Florida BOD
Thread Starter
iTrader: (18)
Join Date: Aug 2003
Location: tampa palms, tampa, florida
Posts: 6,632
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by nsanbyker
Hey guys, I need some help. I'm looking for someone who has an 2003.5 coupe and has installed the shiftlight. I can't get mine to work. Which wires did you 03.5 owners tap into.
Orange goes to blue/yellow vdc wire
Black goes to vdc black
Yellow goes to black wire w/fuse and to ?
Blue goes to ?
I hooked my black/fuse to the cigarette lighter and I can't find a rpm signal wire. Any help is appreciated.
Orange goes to blue/yellow vdc wire
Black goes to vdc black
Yellow goes to black wire w/fuse and to ?
Blue goes to ?
I hooked my black/fuse to the cigarette lighter and I can't find a rpm signal wire. Any help is appreciated.
yellow goes to fuse and the other end goes to the black red wire on teh ignition harness.
blue goes to the crank shaft position sensor wire in pin 13
you can also use one of the other wires that kevin has posted on www.kptechnologies.com/forums
i also responded to your questions on there.
12-11-2005, 10:35 PM
#220
Banned
iTrader: (2)
Join Date: Jan 2004
Location: Ohio
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
No, the power source doesn't matter. In a car, all power originates from the same place. So, as long as your have enough power (which you do) you are fine. Check out the KPtech forum for detailed instructions on how to use a volt meter to find the correct wire.
12-11-2005, 11:16 PM
#222
FGC Central Florida BOD
Thread Starter
iTrader: (18)
Join Date: Aug 2003
Location: tampa palms, tampa, florida
Posts: 6,632
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by nsanbyker
If you could tell what thread to find at kp telling how to use the volt meter, I would be endebted.
12-12-2005, 10:27 AM
#223
FGC Central Florida BOD
Thread Starter
iTrader: (18)
Join Date: Aug 2003
Location: tampa palms, tampa, florida
Posts: 6,632
Likes: 0
Received 0 Likes
on
0 Posts
KPTechnologies Shift Lights
4. Mr pharmD - Dan - White - PAID - shipped
13. Philthy - Phil - Blue - PAID - shipped
17. Demonteverde - Ian - Blue - FL - PAID - shipped
KPTechnologies Window Up
3. Whoojong - Whoojong - TX - PAID - shipped
12. 0TRACK5 - carter - CA - PAID - shipped
13. 0TRACK5 - carter - CA - PAID - shipped
17. mborel7052 - Marc - CA - PAID - shipped
KPTechnologies Auto Door Locking
5. Shooter - Roger - PAID - shipped
KPTechnologies Sunroof Controller*
3. 0TRACK5 - carter - ?? - PAID - shipped
6. mborel7052 - Marc - PAID - shipped
7. Demonteverde - Ian - FL - PAID - shipped
9. BocaCoupe - Rob - FL- PAID - shipped
people who have not received their modules or have not contacted me. please let me know when you receive them
thanks
4. Mr pharmD - Dan - White - PAID - shipped
13. Philthy - Phil - Blue - PAID - shipped
17. Demonteverde - Ian - Blue - FL - PAID - shipped
KPTechnologies Window Up
3. Whoojong - Whoojong - TX - PAID - shipped
12. 0TRACK5 - carter - CA - PAID - shipped
13. 0TRACK5 - carter - CA - PAID - shipped
17. mborel7052 - Marc - CA - PAID - shipped
KPTechnologies Auto Door Locking
5. Shooter - Roger - PAID - shipped
KPTechnologies Sunroof Controller*
3. 0TRACK5 - carter - ?? - PAID - shipped
6. mborel7052 - Marc - PAID - shipped
7. Demonteverde - Ian - FL - PAID - shipped
9. BocaCoupe - Rob - FL- PAID - shipped
people who have not received their modules or have not contacted me. please let me know when you receive them
thanks
Last edited by SFLG35; 12-18-2005 at 07:45 PM.
12-12-2005, 01:24 PM
#224
Registered User
Join Date: Jul 2002
Location: Walnut, the one in So-Cal
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by KPierson
According to the 04 sedan service manual the crank wire is brown, but its pin 95. There are three brown wires, just like the sedan. However, the service manual only documented the A/T tranny, so it MAY differ to the 6mt. I don't have any info on the 6mt!
12-18-2005, 04:20 PM
#225
Registered User
Join Date: Feb 2003
Location: Utah
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
I'm building up the ambition to attempt this mod again. I have a good power source and have correctly spliced into the vdc switch. I am looking for a signal wire. For owner's of 2003.5 coupes with 6 speeds, what color wire did you use from the ecu harness. I have tried all of the brown wires and found one that had the correct idle voltage, but the voltage did not increase with the rev's. I am probably the only person who can take a simple 2 hour job and turn it into a 12 hour nightmare. Thank you in advance for any help.
Last edited by nsanbyker; 12-18-2005 at 05:18 PM.