GTM Performance Engineering: PROJECT VQ42VHR S/C
#46
Moderador
Well, it appears he's been banned. Last post was in 2013 so who knows.
From the tuning evolution that these cars have seen, today this should yield an easy 800whp daily on low boost with tons of torque.
Back then bolted cars would see 300-310 tuned NA and most average FI setups averaging 400-500whp. We now see a 15-20% increase just from the evolution and understanding of ignition/VTC/VVEL angles.
From the tuning evolution that these cars have seen, today this should yield an easy 800whp daily on low boost with tons of torque.
Back then bolted cars would see 300-310 tuned NA and most average FI setups averaging 400-500whp. We now see a 15-20% increase just from the evolution and understanding of ignition/VTC/VVEL angles.
The following users liked this post:
BigSpoon (01-21-2022)
#47
as bull said above development in the last 8-10yrs the results from the first post where impressive then but disappointing now especially considering the built stroker. However this stroked engine with the new FI options and tuning development would probably be a torque monster. Not sure if stroking to that extent would weaken the block walls too much preventing it from being a 1000whp contender. But 700whp with 550-600wtq mid range probably no prob.
With a SC setup that is more limited in max boost vs a big turbo setup, adding the stroked engine might be a good pairing especially with TG rotrex kit.
Thread
Thread Starter
Forum
Replies
Last Post
Sam@GTM
Engine, Drivetrain & Forced-Induction
468
07-21-2016 09:43 PM
Sam@GTM
Engine, Drivetrain & Forced-Induction
108
10-18-2015 11:25 AM
Sam@GTM
Engine, Drivetrain & Forced-Induction
55
01-22-2011 09:58 AM
Sam@GTM
Engine, Drivetrain & Forced-Induction
58
04-16-2010 10:40 AM