When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
We need to get a group buy together - here are pictures of what the shrouds look like. Decide on whether
1. Flat black PC or brushed aluminum finish
2. Vents or no vents
3. Hardware kit or just reuse factory
Brushed Aluminum version for G37
Brush Aluminum version for the G37X
Brushed Aluminum version for the G37 with vent - AWD version would be similar. The oil door has lines that match up with the rest of the shroud to make it look complete.
Same things but in Flat Black Powdercoated finish
Last edited by tollboothwilley; 02-24-2011 at 12:00 PM.
Somehow I totally missed this thread. I sent you my under shield for test fitting/measurements. I like the 3 piece. Will it have additional cooling vents like the other ones you have for the G35?
Somehow I totally missed this thread. I sent you my under shield for test fitting/measurements. I like the 3 piece. Will it have additional cooling vents like the other ones you have for the G35?
I can integrate cooling vents if you'd like. I'm test fitting on Saturday and I'll take a few pics of the prototype.
Originally Posted by javisaman
I'd be interested in one for a 37X sedan. Almost impossible to find. I'll even send over the splash guard!
Can you take a picture of your splash guard and send it to me? Is the G37X similar to the G35X where the oil filter is located towards the front of then engine where the RWD version is located to the rear passenger side?
Originally Posted by RYs06MT
what is en de priceee $$$$?
Price point is set to be around $200 + shipping HOWEVER
IF WE GET A GROUP BUY we can do an introductory pricing and drive that down.
Originally Posted by TomieG
oo exactly what i was looking for...
but i removed the plastic underliner because i was scraping it too much. With this im certainly sure it will scrape.
How much lower does this sit than the original piece? 1"?
This won't necessarily sit much lower than the original piece - you won't really scrape too often with this. However, it will still allow for you to utilize a 1" oil pan spacer if you'd like.
Can you take a picture of your splash guard and send it to me? Is the G37X similar to the G35X where the oil filter is located towards the front of then engine where the RWD version is located to the rear passenger side?
My splash shield is pretty messed up. I did find an image from a store though that might help.
Ok, I'll need to check on it, but it looks like the G37X is very similar to the G35X - but it probably has the same dimensional changes that took places between the G35 -> G37 (a little wider, hole locations, etc).
Ok, I'll need to check on it, but it looks like the G37X is very similar to the G35X - but it probably has the same dimensional changes that took places between the G35 -> G37 (a little wider, hole locations, etc).
I forgot to mention that I have a g35X 2nd gen sedan (2007). I assume it has the same splash shield as the g37 sedans.
I think you're right. They all use an HR motor, so all 2007-2010 AWD version should be the same, and the 2007/2008-2010 3.5 and 3.7 HR motors are probably all the same.
What I find interesting is that the 370Z still has the same design as the G35.
I just need to meet up with my test vehicle one more time.
Last edited by tollboothwilley; 09-07-2010 at 03:48 PM.