DIY: Dball/dball2 installation diy
#61
Registered Member
I partly used this DIY to install my Fortin EVO-NIST1 that I'm struggling to get to actually start my car, despite believing I have it properly flashed, installed and programmed. So tracing and retracing my steps, I'm wondering about the brake sensor switch that I removed to change swap the connectors. It seems like but design, it can be installed at any height. Unfortunately I did not mark its height before removal. Any idea how to know what height to install it at? Thanks
#64
Premier Member
#65
#66
Premier Member
Ah man sorry to hear that, but glad you love it
Thread
Thread Starter
Forum
Replies
Last Post