Your wire will be insulated to protect the copper, but there is a PVC woven sheath you can put around the insulation to guard against rubbing and abrasion. There's also heat insulation available if you want, I didn't get it.

 

Oh okay. Good tip. Thanks

 

Okay... Installed "grounding kit". The verdict is still out......

 

No. This thread really HAS come to a verdict.

 

Audio may be a little louder, but I haven't felt a difference in DS mode shifting or throttle response. I bet the Uprev tune will cure all THOSE ailments though.

 

Can I get that with two spoons of sugar

 

And a WHOLE LOT MORE! Uprev T-minus 3 weeks and counting!

 

[QUOTE=AZg37;3116373]
What size eyelits do i need?

 

Holy ****. Quoted the entire post and apparently didn't read ****, because it says so right on the first few pics. 8 gauge and 4 gauge.

 

Ordering 4 and 2 g copper post, the vendor wants to know what size ring / eyelet for when you ground it.

 

Was skeptical myself but shifts were drastically improved in Sport paddle mode. Thanks for the DIY

 

AZg37,

Kudos my man, this DIY is up there with the best on this site! Shifting is spot on now in DS mode and audio is noticeably improved!!

Thanks mate!
doug

 

Do you guys get stranded or solid?

 

Stranded

 

I made my kit with stranded cable, better conductivity, more pliable and stronger to boot. used the recommended cable size, 8 and 4 gauge also. I didn't go crazy with the quality cable and bought my stuff from home depot, and eyelets from a car audio store. I used shrink tubing to cover any bare cable to connector.

Audio in my car is better. Tranny shifting is better up and down. It is noticeable... Also don't wait for the factory recommended 105,000 miles to change your plugs. Incredible difference when all is said and done.

Doug