Request:Need help installing white leds for rear license plates lights
11-12-2010, 04:53 AM
#16
Hey i checked on the USDM, and yea, i just realized you guys don't have that side turn signal on your fenders... damn.. i'm alone on this then.. i wonder how i can open them.. Thanks for the help though.
08-17-2011, 04:57 PM
#20
Per your request, here's the dome and door light install. Just need a flat head screwdriver with some tape on the tip so that you don't scratch anything.
The dome light is a simple pop out, don't worry you won't break anything. It has four clips, two on each side....
The door lights are the same, pry it out. Then I would recommend disconnecting the wire harness, just push down the little clip and it'll come right off. Then, you'll want to pry off the clear plastic piece. Just pop one side off and you should be good to go. Once again, don't close everything up and put it back together until you verify you have them in correctly...
The dome light is a simple pop out, don't worry you won't break anything. It has four clips, two on each side....
The door lights are the same, pry it out. Then I would recommend disconnecting the wire harness, just push down the little clip and it'll come right off. Then, you'll want to pry off the clear plastic piece. Just pop one side off and you should be good to go. Once again, don't close everything up and put it back together until you verify you have them in correctly...
nice man, thanks for doing this
Thread
Thread Starter
Forum
Replies
Last Post
superjoey
D.I.Y. Installations/Modifications
31
03-22-2023 11:56 PM
maybeg37
Body Interior Exterior Lighting
9
09-08-2015 02:33 PM
