When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I, also, have only been using Zaino, in several layers. When you put the wax on top of the Zaino, and then in a few weeks when I go to put on another layer or two of Zaino, is there anything I do to prepare the waxed surface prior to the Zaino? Have any of you had experience seeing how the Zaino will respond when placed over a layer of high quality wax?
I also do not think that the Zaino will stick to the wax.
I just purchased the new Porter Cable 7424 setup with backing plate, and different pads, etc. I have not tried it yet. If I put the layer of carnuba wax over the Zaino, then in the near future go to remove the wax prior to another round of Zaino sealant---about how long does it take to remove the wax with the clay bar, and Porter Cable and appropriate polishes. Just curious how much time the wax removal adds to the routine the day of the detail, on average, for those of you who have done this.
I just purchased the new Porter Cable 7424 setup with backing plate, and different pads, etc. I have not tried it yet. If I put the layer of carnuba wax over the Zaino, then in the near future go to remove the wax prior to another round of Zaino sealant---about how long does it take to remove the wax with the clay bar, and Porter Cable and appropriate polishes. Just curious how much time the wax removal adds to the routine the day of the detail, on average, for those of you who have done this.
You will remove all your wax/sealant in a single wash with Dawn and a complete clay bar treatment. Wash after claying again with Dawn. You have now stripped off all wax and sealant and are ready to polish/seal/wax anew.
12-04-2008, 04:31 PM
