@mattlorentzoe’s G37x build (mid 12s n/a)
The following users liked this post:
jpowersjr2 (01-07-2019)
01-08-2019 | 09:09 AM
#230
Thread Starter
Premier Member
iTrader: (4)
Joined: Jun 2015
Posts: 773
Likes: 156
From: Gwinnett County, Georgia
Yes I went lol. Man these bracket racing events are serious. Cars must of come from states all around the south lol. Thousands of people there. Only got 2 runs (both not good) in 12 hrs. Plus the 5 hours of drive time to get there and back hahaha. Dialing in dampening. Really struggling with tire temps this time also. Hahah everyone was super far from there goal they set for the day. We failed together haha! Haven’t forgot about your scales either bro! Lol I really get to get those back to you one day. Got the g down to 3575 with half tank of gas!
01-14-2019 | 11:25 AM
#233
Thread Starter
Premier Member
iTrader: (4)
Joined: Jun 2015
Posts: 773
Likes: 156
From: Gwinnett County, Georgia
Got a killer deal on some SPL traction arms. Thanks again @NeverBoneStock
Just need to get the spl bumpsteer tie rods and to swap the ksports for stance or feals coilovers soon! Other than that, couldn’t be happier with the setup. Also have fast intentions non resonated test pipes order to replace my fastintentions resonated test pipes!!!! Minor changes coming in the next month or so then saving for boost.
Just need to get the spl bumpsteer tie rods and to swap the ksports for stance or feals coilovers soon! Other than that, couldn’t be happier with the setup. Also have fast intentions non resonated test pipes order to replace my fastintentions resonated test pipes!!!! Minor changes coming in the next month or so then saving for boost.
01-14-2019 | 11:28 AM
#235
Even at the height I'm currently at, I don't remember having a lot of bumper steer. I currently have the SPL outer tie rods just cause. Are you experiencing a lot of bumper steer?
Latez
Latez
01-14-2019 | 11:55 AM
#236
Thread Starter
Premier Member
iTrader: (4)
Joined: Jun 2015
Posts: 773
Likes: 156
From: Gwinnett County, Georgia
Lol so I am having some issues with traction off launch. I just wanted to get those also so everything can be fully adjustable. Steering is super sloppy though and it’s a fail point I don’t want to have to deal with. Eventually I’ll spend the $400 on it lol. Eventually
The following users liked this post:
Calg37USMC (01-15-2019)
01-19-2019 | 07:16 PM
#238
Did you contact Bell about the rust issue? I just received mine. Maybe I should put some sort of coating over it to protect it from rust.
Last edited by jpowersjr2; 01-19-2019 at 07:27 PM.
02-02-2019 | 08:22 AM
#239
Thread Starter
Premier Member
iTrader: (4)
Joined: Jun 2015
Posts: 773
Likes: 156
From: Gwinnett County, Georgia
Yes I did. All good there. Great company. They have since fixed the coating issues but not on mine lol. No hard feelings at all, can have it done for relatively cheap. Authur is a great guy.
The following users liked this post:
jpowersjr2 (02-02-2019)