Another G Sedan Going Air
The following users liked this post:
07 Ivory Pearl (05-22-2013)
#20
Did some trunk work last night. Using 1in thick wood. I am making one more cut in front of the tank to get to the spare wheel. Going to mount the air compressors above the tank for more room.
The following users liked this post:
kevshiau (05-17-2013)
#21
Temporarily installed my Kuda Cell Phone mount with Accuair Switch Speed. I installed counter sunk magnets and screwed them to the corners (made for permanent installs) and epoxy square magnets on the underside of the mount so I can use the wired remote in the car or outside of the car. I didn't run the wire just yet but will be doing so soon when I install the Digital Air Pressure gauge. I will have the entire car wired for each corner and tank shortly. The gauge will be functioning just throwing error codes till the sensors are connected to the manifold and pressure in the tank. I was going to do a permanent install on the controller (and I still can) but liked the idea of having it able to detach. They also give you a ton of slack to hit switches outside of your car. I will have most of the slack tucked inside the dash except for a few feet that I will spool into the space of the mount.
#22
Another update I installed the Stance coilovers and slammed it. I ordered the propper bags and brackets for the front coilovers which shall be here Friday and the rear bags my buddy will be getting when the final install goes down in July which will be cup style. In the mean time I will be static and setting my trunk and wiring everything up and just getting it all ready for the lines and bags. Some pics of her slammed on my old rims I had for my 07 Altima.
#23
Just a little update the car is in the shop getting the rest of the air ride put in. Here is a teaser pic of the rear along with my last mock up of the freshly powder coated tank/accuair exo mount and compressors.
#24
Nice! By the way, the arms are only $15 to replace. If installed correctly, they will be fine. I have installed these on a sedan and a coupe (IG usernames: @v36boss @swg37stout)
Updated e-Level Sensor Arm - OPEN ROAD TUNING
Updated e-Level Sensor Arm - OPEN ROAD TUNING
#27
Thanks! Here's a few pics of the completed setup. Tank and mounts (minus compressor shelf) are powder coated white with glow in the dark blue powder int he clear. Hard to get a shot of glowing. I also mounts 3ft LED strip to to make everything pop. I have the 6 disk changer in the trunk which hides my one compressor I will be eliminating this shortly after my 2010-2013 non-Sport conversion is done. (I like the non-Sport the best bc it resembles 07-09 Sport with added fogs).
The last pictures shows the glow in the dark powder in the clear with a slight hit of light charge t it. I have UV LEDs that I will be hidden but aimed at the tank to enhance the glowing of the tank when the white LED strip is off.
The last pictures shows the glow in the dark powder in the clear with a slight hit of light charge t it. I have UV LEDs that I will be hidden but aimed at the tank to enhance the glowing of the tank when the white LED strip is off.
#29
Sorry for long awaited update pics.
I will be getting new and more aggressive wheels. Also I got my new License plates installed in this pic.
Some pics of the clock air gauge. The silver button when pressed gives my my tanks air pressure. The OEM buttons on the left and right are dummies and non functional.
I will be getting new and more aggressive wheels. Also I got my new License plates installed in this pic.
Some pics of the clock air gauge. The silver button when pressed gives my my tanks air pressure. The OEM buttons on the left and right are dummies and non functional.