Any IPL owners dropping their rides?
#18
Registered Member
iTrader: (9)
The following users liked this post:
JMS2000 (05-03-2013)
#22
Bumpity
Hey Robby, I'm digging your ride height... I'm looking to lower my IPL very shortly and I'm debating on how low to go. I want a similar look - OEM wheels, no spacers. Do you have anymore pics, from different angles, etc.? Thanks dude.
#24
Ordered my parts! KWv1 coilovers and SPC F/R alignment kit. I'll see how it looks then decide whether to get some 20mm spacers. Pics forthcoming.
Edit: Parts are IN! They should be installed within a week or so... woohoo!
Edit: Parts are IN! They should be installed within a week or so... woohoo!
Last edited by JMS2000; 08-17-2013 at 07:46 PM.
#26
Registered User
iTrader: (1)
I just installed aragosta. Still setting the height. I have a question for the guys who are lowered to just above the stock wheel...any issues with speed bumps? I've been trying to figure out how low I plan to go and haven't dialed it in yet. I wouldn't worry if I could get my hands on the Roberuta cup set but not quite ready to spend that extra bit of money yet.
#27
KWv1 coilovers and SPC alignment kit were installed last week. Springs have settled, coilovers are adjusted, alignment is complete... Let's roll!
Ride height is set to 26.5" front 26.75" rear and the alignment is to OEM spec. I can tell already that it needs spacers. It doesn't look bad now, but it'll look better after I install 20mm around. Will post some pics this weekend.
Ride height is set to 26.5" front 26.75" rear and the alignment is to OEM spec. I can tell already that it needs spacers. It doesn't look bad now, but it'll look better after I install 20mm around. Will post some pics this weekend.
The following users liked this post:
wattles (07-27-2014)
Thread
Thread Starter
Forum
Replies
Last Post
tomro99
Private Classifieds
6
11-17-2015 02:08 AM