djsp

I just recently installed H&R springs and I haven't driven the car too much because the car still needs alignment, and from my right fender I hear a clicking noise. I think its the camber arm hitting the fender I'm not sure.

I did a search and read thorough the SPC problem they had a while back but its only coming from one side. Do I need bump stops cause I didn't put any in when installing the arms and I do have the right part number I did check.

Should I fix this before getting alignment? or is this something else...

Weiboy718

iTrader: (10)

did you check to see if the sway bar end links are tight? also did you use those little washers they provided on each bolt. that sound might be caused by metal to metal contact.

djsp

I didn't put any in, but its only happening on one side, so would i have to but them on both sides? and where do they go?

Weiboy718

iTrader: (10)

put them inside the bolt for the camber arms. like you do for the washers. do you have 8 of those nylon washers?

djsp

yea i have 8 of them, should I fix this before getting alignment?

TVPostSound

iTrader: (9)

Those nylon washers are there to raise the bump stop on the strut's shaft.

djsp

any pics im really confused on where they go?

djsp

ok so i got alighnment today and the noise is gone =) now cause the camber is corrected my car went a tad bit higher =(

TVPostSound

iTrader: (9)

You must have left the ball joint top adjustment nut below torque spec (loose), and it was moving.
It's now tight, since the alignment tech must have torqued it.
You know it's 120 ft lbs!!

Camber wont raise car.

djsp

i spoke too soon and the squeaking is a lot less now but i can still hear it on certain roads