When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
What the heck is this in the pic? Is this what everyone is rubbing on?
I dont have a clue what it is for... Anyone???? Is this what everyone rubs when lowered or Wide wheels? Its the bracket thingy with 2 holes in it... for those who dont have a clue what I'm talking about...
Last edited by MaxToTheG37; 04-17-2008 at 12:21 AM.
Haha that actually had me worried so I just checked. I have the same thing, no idea what its for but its about 2-3 inches away from my wheels (20x10.5 +36 rears) and that would never touch it. Took a picture but phone is being stupid so can't upload it.
No you wont come close to that piece. I had to grind the tab that is on the inside of the fender that holds the fender to the bumper. If that makes sense.
Prolly not cause I would have to take my wheel back off and I dont plan on doing that until my new sensors come in. If you can wait a week or so but I dont think you can.
maybe someone will snap and pic of where its and and you can explain it then... dont take you wheel off just to take a pic tho... its not that big of a deal... Ill find out sooner or later somehow...
Just reach up inside the wheel well near the top but then a little back where the bumper and fender meet. There is a tab and a screw or bolt in it that hold the 2 sections together. You can't miss it if you run your hand around the edge of the inside of the well.