Screwed up trying to swap out the springs!
#31
Registered Member
Yea that's what I was thinking 7/16 would be good too, if it s a little loose thst fine you can deal with the noises for a few days, but yea the washers will be good to add some length if the threads arnt in the right place....good luck let us know when everything is on good and lowered...where do you live??
The following users liked this post:
Dan G37 (07-31-2017)
#32
Registered Member
Thread Starter
Yea that's what I was thinking 7/16 would be good too, if it s a little loose thst fine you can deal with the noises for a few days, but yea the washers will be good to add some length if the threads arnt in the right place....good luck let us know when everything is on good and lowered...where do you live??
The following users liked this post:
Dan G37 (07-31-2017)
#34
Registered Member
Thread Starter
#35
Registered Member
Thread Starter
The bolt I need is for figure 17 do you think 7,8 would be the bolt for that one?
Nvm figure 17 gets placed on top of 6, 17 just holds the strut in place!
The following users liked this post:
Dan G37 (08-02-2017)
#37
Registered Member
Thread Starter
Hey I took my car to the shop and they did the suspension, They changed the front struts out because one of them was really worn. I have a question though. My rear used to be lower then the front, Rear was 26.25 inches from the bottom of the wheel to the wheel fender, the front was a little under 27. Now the front is at 28 inches and the rear is at 28.5. Is this normal?
#38
Registered Member
Hey I took my car to the shop and they did the suspension, They changed the front struts out because one of them was really worn. I have a question though. My rear used to be lower then the front, Rear was 26.25 inches from the bottom of the wheel to the wheel fender, the front was a little under 27. Now the front is at 28 inches and the rear is at 28.5. Is this normal?
The following users liked this post:
Dan G37 (08-02-2017)
#39
Registered Member
Thread Starter
did they use stock springs and shocks? The only thing I can think of is if they didn't use Nissan struts and maybe they are slightly longer,or if they replaced the springs and since they are new they don't sag as much as the old ones, or if they replaced the upper mounts those are new and not worn down...all of that together could maybe move it 1/2" I guess
#41
Registered Member
Thread Starter