Review Tein Basis coilovers on '13 G37S sedan 6spd
#76
Registered User
The following users liked this post:
Kpmikey808 (11-29-2017)
#81
Its usually the shoulders around the ball joint where you loosen the bolts for adjustment. This area is a good bit longer/wider than the stock arm. Honda guys frequently have this issue. Its why most of the nicer (amd even SPC’s own higher end version) control arms adjust along the arms themselves rather than at the ball joint.
#85
Registered User
Just figured something out. These springs sag a little over time. Car is a good 1/2" lower than when I settled on my height. In the front, no problem, plenty of room. In the back, no bueno, I'm tucking tire at what I remember being the top setting. I just ordered a spring spacer but I will see if I have adjustment room over the Thanksgiving break.
#88
Registered Member
Just figured something out. These springs sag a little over time. Car is a good 1/2" lower than when I settled on my height. In the front, no problem, plenty of room. In the back, no bueno, I'm tucking tire at what I remember being the top setting. I just ordered a spring spacer but I will see if I have adjustment room over the Thanksgiving break.
my teins settled about 1/4 inch i believe
ill take different measurements FTG cause of uneven surfaces
i was 26.5 and after i measured was 26.25
#89
I need to raise my front end up. I was at 26 1/4 and they settled to 25 3/4...way to low, hitting some vertain bumps, well actually dips, UCA hitting top of wheel well I think. But, the ride is awesome with these CO and Sways, just what I was looking for. Almost like stock, but so much more planted, and barely any roll. Im very happy!
#90
Registered Member
Teins settled lower
I need to raise my front end up. I was at 26 1/4 and they settled to 25 3/4...way to low, hitting some vertain bumps, well actually dips, UCA hitting top of wheel well I think. But, the ride is awesome with these CO and Sways, just what I was looking for. Almost like stock, but so much more planted, and barely any roll. Im very happy!
Marcel did u have mechanic install yours
Post some pics marcel so I can see please