help needed!! with g37x coupe brakes..
#16
Registered User
Front right 12742080R
Front left 12742080L
Rear left 12742088L
Rear right 12742088R
Correct? 320mm all around?
Last edited by farmurr; 09-17-2013 at 10:48 AM.
#17
Registered User
LOL, I am keeping up, he mentioned the concern about cutting slotted/drilled rotors as that's what he upgraded to.
Wild_pea, good luck through all this, it's really a shame there's such a mystery regarding the correct fit for the G37X coupe, sure hope you get the right parts and hopefully you won't be on the hook for much of the return.
Wild_pea, good luck through all this, it's really a shame there's such a mystery regarding the correct fit for the G37X coupe, sure hope you get the right parts and hopefully you won't be on the hook for much of the return.
So you are (keeping up); my bad!
And you are spot on about it being a bad idea to try to cut the new rotors down to fit; much better to just start with the correct part!
The following users liked this post:
blnewt (09-17-2013)
#19
Movin On!
iTrader: (13)
Might also want to check w/ KNS brakes just to confirm fitment, they've been selling a lot of G brake parts around here.
The correct fit would make a nice sticky thread so others can avoid what's happened to the OP.
The following users liked this post:
wild_pea (09-17-2013)
#20
That seems to be the big question, since most of the part sites don't specifically list the G37X coupe, it list the sedanX, and all the RWDs but the coupe X seems to be left off for the most part.
Might also want to check w/ KNS brakes just to confirm fitment, they've been selling a lot of G brake parts around here.
The correct fit would make a nice sticky thread so others can avoid what's happened to the OP.
Might also want to check w/ KNS brakes just to confirm fitment, they've been selling a lot of G brake parts around here.
The correct fit would make a nice sticky thread so others can avoid what's happened to the OP.
Thread
Thread Starter
Forum
Replies
Last Post
drewfinity
Newbie Corner
15
08-20-2015 08:17 PM