Input needed for Swift Springs
#1
Registered User
Thread Starter
Input needed for Swift Springs
Looking to get some feedback on Swift springs. Most notably, how hard it is to get around, can you DD without scraping too often? Also, what camber kits will you need to get back into spec? I'm assuming a rear camber kit is needed.
Recommended struts? Car has 68k.
Thanks!
Recommended struts? Car has 68k.
Thanks!
#2
I had Swift and used a rear kit.. front no but would've helped a lil... I had them on a few months then went to Tien...wanted a lower stance but after 3-4 mo later now on Stance SS's best decision yet ...
as for scraping not much if any with Swift.. Tein a little more... but both aren't bad... to me Swift was stiffer... Tien was a softer smoother ride... jmo...
Now on coils Yeah! Stiff and smooth...
struts... thats not bad on millage.. just toss them on till its time to change out...
as for scraping not much if any with Swift.. Tein a little more... but both aren't bad... to me Swift was stiffer... Tien was a softer smoother ride... jmo...
Now on coils Yeah! Stiff and smooth...
struts... thats not bad on millage.. just toss them on till its time to change out...
The following users liked this post:
Darkstar752 (06-20-2013)
Thread
Thread Starter
Forum
Replies
Last Post