Rear Sway Bar Upgrade
#124
Registered Member
iTrader: (1)
Rear Sway Bar Upgrade
I hate to be contrary, but I think you meant Audi and it had 115,000 miles on the original suspension and it didn't wander. I looked at the entire suspension on this G37 up in the air and the only thing bad on it was all 4 original end links were worn out.
#127
Just swapped 12' G37X sway
Just swapped my old rear sway with a sway from a Rwd sedan and it feels great. The Rwd sway is sooo much thicker and a little longer. The stock G37x sway Awd is way too skinny and wimpy. Def recommend the upgrade.
#128
Where do you buy this Rear Sway Bar for reasonable cost?
I have an X - do you reccomend Ebay? It would seem there would be a lot of these available.
Do you need any other hardware other than the bar?
I have an X - do you reccomend Ebay? It would seem there would be a lot of these available.
Do you need any other hardware other than the bar?
#132
Would these bushings work as replacements? I've never heard of Moog? Was thinking about getting OEM ones. I purchased the RWD bar off ebay already now looking to install.
Also - as far as dropping the exhaust - how hard is this? I hear it needs to be lowered to fit the sway bar in place?
Suspension Stabilizer Bar Bushing Kit Front MOOG K200283 | eBay
Also - as far as dropping the exhaust - how hard is this? I hear it needs to be lowered to fit the sway bar in place?
Suspension Stabilizer Bar Bushing Kit Front MOOG K200283 | eBay
Last edited by peterso2; 11-01-2016 at 08:52 PM.
#133
Registered Member
Would these bushings work as replacements? I've never heard of Moog? Was thinking about getting OEM ones. I purchased the RWD bar off ebay already now looking to install.
Also - as far as dropping the exhaust - how hard is this? I hear it needs to be lowered to fit the sway bar in place?
Suspension Stabilizer Bar Bushing Kit Front MOOG K200283 | eBay
Also - as far as dropping the exhaust - how hard is this? I hear it needs to be lowered to fit the sway bar in place?
Suspension Stabilizer Bar Bushing Kit Front MOOG K200283 | eBay
Yes you need to drop the rear section of the exhaust. Not hard at all. If my memory serves me right, I believe I swapped out the rear sway bar with the car still on the ground.
The front sway bar definitely requires the car to be lifted up though.
#134
Those bushings you listed are for the front.
Yes you need to drop the rear section of the exhaust. Not hard at all. If my memory serves me right, I believe I swapped out the rear sway bar with the car still on the ground.
The front sway bar definitely requires the car to be lifted up though.
Yes you need to drop the rear section of the exhaust. Not hard at all. If my memory serves me right, I believe I swapped out the rear sway bar with the car still on the ground.
The front sway bar definitely requires the car to be lifted up though.
Last edited by peterso2; 11-02-2016 at 03:10 PM.