What is your SPC front control arm set to for caster adjustment?
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: East Bay, CA
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
What is your SPC front control arm set to for caster adjustment?
I'm trying to figure out what to preset the SPC front camber arms to before I go for an alligment.
I know all our cars might react differently to drops, but I'm just trying to get a general idea of where to set it to (+1, +.75, +.50, 0, -.50, -.75, -1)
Even if you don't have the spc front arms, how did your allignment turn out? Did it show you needed positive or negative caster to get you back to spec?
Right now without an alligment my car is dropped exactly 26.5 front and rear on both sides from ground to top of the fender lip (kind of freaky, but it happend by accident on the first shot).
TIA
I know all our cars might react differently to drops, but I'm just trying to get a general idea of where to set it to (+1, +.75, +.50, 0, -.50, -.75, -1)
Even if you don't have the spc front arms, how did your allignment turn out? Did it show you needed positive or negative caster to get you back to spec?
Right now without an alligment my car is dropped exactly 26.5 front and rear on both sides from ground to top of the fender lip (kind of freaky, but it happend by accident on the first shot).
TIA
Thread
Thread Starter
Forum
Replies
Last Post