305/GT30/KWv3/SPC Rear = NO rub!
#18
Registered User
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: West Bloomfield, Michigan
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
Actually, I'm going with Carbon Fiber Grill (w/ Mt. Fuji emblem) & Carbon Fiber Headlights (which will be sent to Igor @ 180) from IvoryGT. I'm also planning on ordering the Stillen Front Splitter and having IvoryGT wrap it in Carbon Fiber. Lastly, I'll be ordering either Status Elite's or Igor's Carbon Fiber Rear Diffuser. I'm considering getting the Carbon Fiber Roof Overlay. The Center Caps on the GT30's are High Polished w/ a Red Ring and Carbon Fiber Center Cap so It'll all tie in together. *Possibly Considering Carbon Fiber faced rims in the future too, we'll see.
#20
Florida G35 Club, Premier Member
iTrader: (3)
Join Date: Oct 2005
Location: Orlando, FL
Posts: 2,508
Likes: 0
Received 0 Likes
on
0 Posts
Whoa dude, nice!! I know what i'm getting for my next set of tires. Do you think you can go any lower?
Whats the measurement from the ground to the apex of the rear fender? Mine is at about 26" and i want to know if i can maintain that height.
Whats the measurement from the ground to the apex of the rear fender? Mine is at about 26" and i want to know if i can maintain that height.
#21
Registered User
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: West Bloomfield, Michigan
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
I'm sure I could go even lower if I wanted to, maybe another 1/2"-3/4" max, maybe if it wasn't a daily driver. But, then I think there would definitely be the possibility of rubbing issues. I can't seem to find my measuring tape so I haven't yet measured from the ground to the apex of the fender yet. I'm guessing around 26" but we'll see. I'll try and find the measuring tape in the AM and post up some more information.
#24
Registered User
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: West Bloomfield, Michigan
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
Just found my measuring tape, was looking all over for it. And, where was it? I'm my freakin' tool box where it belongs, LOL. Anyways, I measured from the ground to the apex of the fender (while on my sloped driveway) and the measurement is between 25.5" and 25.75" all around. After I get the SPC front camber kit and have it installed I will have MRT readjust the hight to get all four corners to match perfectly (hopefully!).
#29
Premier Member
iTrader: (7)
Actually, I'm going with Carbon Fiber Grill (w/ Mt. Fuji emblem) & Carbon Fiber Headlights (which will be sent to Igor @ 180) from IvoryGT. I'm also planning on ordering the Stillen Front Splitter and having IvoryGT wrap it in Carbon Fiber. Lastly, I'll be ordering either Status Elite's or Igor's Carbon Fiber Rear Diffuser. I'm considering getting the Carbon Fiber Roof Overlay. The Center Caps on the GT30's are High Polished w/ a Red Ring and Carbon Fiber Center Cap so It'll all tie in together. *Possibly Considering Carbon Fiber faced rims in the future too, we'll see.
I want to do the same thing with black chrome. I'm afraid the black chrome will cost too much and the carbon fiber is a nice alternative.