I was wondering that since the tails as turn module comes with the integrated 6 ohm resistors to prevent hyper flashing, that if I were to add LEDs to the front turn signals, what ohm resistors would I need?

 

No you need a resistor at each bulb location.

 

Yeah I knew that but I know a pair of 3 ohm resistors negates hyper flash for both front and rear led turn signals. But the module has the integrated 6 ohm just for the rear turn signals so I was just wondering if a resistor would be needed if I were to add front LEDs to the turn signal. But I guess the better solution would be desolder the 6ohm and put a 3 ohm in its place. unless someone knows a different solution