Replacing Int. Light Blubs 2013
#1
Registered Member
Thread Starter
Replacing Int. Light Blubs 2013
Is there someplace that shows how you open the Int. light covers (With out breaking them)
I plan on changing out all the Int. light bulbs
I plan on changing out all the Int. light bulbs
#3
Registered User
I assume by Int. you mean interior ... in the light forum, tons of posts and DIY's
#4
Registered User
What I did was I took the slimmest flathead I had, and wrapped it any type of clear tape...It'll prevent scratches. and all you do is start on one side, pop the clip you, then do the other side and then run it around and it comes out. Unless you're really forcing something you shouldnt break anything.
#5
Registered Member
Thread Starter
What I did was I took the slimmest flathead I had, and wrapped it any type of clear tape...It'll prevent scratches. and all you do is start on one side, pop the clip you, then do the other side and then run it around and it comes out. Unless you're really forcing something you shouldnt break anything.
"Unless you're really forcing something you shouldnt break anything."
That's what I'm afraid of.
I ordered Astro Punumatic 4524 - 11 pc. Fastener and Molding Removal Tool Set
Astro Punumatic 4524 11 PC Fastener and Molding Removal Tool Set | eBay
So we'll see
Thread
Thread Starter
Forum
Replies
Last Post
superjoey
D.I.Y. Installations/Modifications
31
03-22-2023 11:56 PM
bikerjosh
Body Interior Exterior Lighting
5
08-19-2015 11:26 PM
drkashifa
General Tech Questions
5
08-15-2015 01:27 AM