Quad Xenon Dual Projectors
12-27-2011, 06:47 PM
#1
Quad Xenon Dual Projectors
Just finished my retrofit project. Used the Morimoto Mini H1 projectors. Also swapped out the stock lens with a clear one and modified the shield. Onto pics:
Update:
Decided to paint them after all. Reopened the lights and painted.
Installed pics:
Update:
Decided to paint them after all. Reopened the lights and painted.
Installed pics:
Last edited by Modme; 01-14-2012 at 07:29 PM.
12-27-2011, 09:59 PM
#3
Didn't paint them. I tested on a spare shroud and it didn't turn out that well. It looked good unpainted so I left them.
I didn't have to cut any part of the housing but the bulb does stick out the back. I plan to seal it with a rubber cap.
I didn't have to cut any part of the housing but the bulb does stick out the back. I plan to seal it with a rubber cap.
Last edited by Modme; 12-28-2011 at 01:13 AM.
12-29-2011, 01:18 AM
#7
looks real good. in the output shots you posted, is that just the headlight on or the whole quad setup?
you used the MH1 projector right? not the morimoto matchbox projector?
is the bixenon of the MH1 also wired up?
you used the MH1 projector right? not the morimoto matchbox projector?
is the bixenon of the MH1 also wired up?
Trending Topics
12-29-2011, 12:20 PM
#8
The output shot is with just the mh1 on. The matchbox will probably fit in the housing easier. And yes, high beam is setup too. I simply hooked up the actuator motor to the stock wires. I'm planning to install the kptech foggiest module so that the foglight does not turn off with the high beam.
01-03-2012, 08:17 AM
#12
Wow thats amazing..
I have few questions if you dont mind.
1. how did you wire the high beam of the new projector with the stock high beam wires
2. is there any cutting needed in the housing or the headlight?
3. how did you mount the projector to the headlight after removing the foglight reflector thing
I have been looking for this for a long time!
I have few questions if you dont mind.
1. how did you wire the high beam of the new projector with the stock high beam wires
2. is there any cutting needed in the housing or the headlight?
3. how did you mount the projector to the headlight after removing the foglight reflector thing
I have been looking for this for a long time!
01-03-2012, 11:34 AM
#13
1. There are two wires coming out the stock projector solenoid. I simply soldered the wires into the stock ones.
2. No cutting of stock housing. The new projector sticks out the existing bulb hole about 2 inches.
3. I pulled out the fog reflectors and made brackets that utilIzed the stock bolts. This allowed the new projectors to be height adjustable like stock.
2. No cutting of stock housing. The new projector sticks out the existing bulb hole about 2 inches.
3. I pulled out the fog reflectors and made brackets that utilIzed the stock bolts. This allowed the new projectors to be height adjustable like stock.
