Headlight color code diagram, anyone got one?
08-03-2010, 08:37 PM
#16
The wire harness that powers the HID is connected to the ballast and it's got a steel-wool-like sleeve covering it. But there are 2 small wires (bluish green color) that connect to a plug right below the HID. I think those might be the high beam mechanical trigger. Maybe you can try splicing into those. Good luck!
08-04-2010, 11:14 AM
#17
Np, the wires I'm talking about are very difficult to get to. It's inside the HID compartment. If you open the HID cover and look straight into it, it would be located near the bottom. I don't think you'd be able to reach the clip by hand. I use pliers to pull on the wires and simultaneously another tool to unclip it from the plug. It's like performing surgery.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
08-10-2010, 03:17 AM
#18
Took it back to the stereo store I used to work for and my friend used a multi-meter to check the wiring. Works like a charm 
If anyone's interested and buys one of the modules, I'll go and check the color codes.
If anyone's interested and buys one of the modules, I'll go and check the color codes.
08-10-2010, 12:24 PM
#20
If by "flash" you mean illuminate the high beam of the bulb, then yes it does as I have to flick the headlight stalk twice to open the door.
I'm not really concerned about long term issues as I have the 7/100 warranty. Also, I had it installed over 2.5 years on the 3 without any problems
I'm not really concerned about long term issues as I have the 7/100 warranty. Also, I had it installed over 2.5 years on the 3 without any problems
Thread
Thread Starter
Forum
Replies
Last Post
