Body Interior Exterior Lighting
Sponsored by:
Sponsored by: CARiD

window not going all the way up

Thread Tools
 
Search this Thread
 
Old 02-22-2010 | 10:36 AM
  #1  
Krebo's Avatar
Krebo
Thread Starter
Registered User
 
Joined: Jan 2010
Posts: 85
Likes: 0
From: Bergen
window not going all the way up

Is there anything i can do without going to the dealer to fix my window issue? The window will not reset itself to the correct position using the 15sec down then up rule. It stops about 1cm or less before the actual position. You dont really notice a difference at low speeds. However at 60+ mph you get a whistling noise which is starting to annoy me.
Old 02-22-2010 | 11:46 AM
  #2  
Surfdog's Avatar
Surfdog
Registered User
 
Joined: Jun 2008
Posts: 39
Likes: 1
From: Toronto
Hey Krebo,

Have you tried disconnecting the battery? That should "reset" the computer. We did that to my friend's M3 when his auto up/down was broken.
Old 02-22-2010 | 11:59 AM
  #3  
Krebo's Avatar
Krebo
Thread Starter
Registered User
 
Joined: Jan 2010
Posts: 85
Likes: 0
From: Bergen
I will definatly give it a shot and see if it helps. Is there anything else that gets reset when disconnecting the battery?
Old 02-22-2010 | 12:26 PM
  #4  
Xcalibur's Avatar
Xcalibur
Registered Member
iTrader: (2)
 
Joined: Aug 2008
Posts: 1,386
Likes: 14
From: Miami, Florida
I think the seat/rear view mirror settings get reset too.
Old 02-22-2010 | 03:33 PM
  #5  
csnpsu's Avatar
csnpsu
Registered User
 
Joined: Jan 2010
Posts: 303
Likes: 0
From: Skilllman, NJ
When did you buy the car?

Just take it to the dealer
Old 02-23-2010 | 06:40 PM
  #6  
Dieseldoug22's Avatar
Dieseldoug22
Registered User
iTrader: (27)
 
Joined: Oct 2007
Posts: 912
Likes: 2
From: Azusa, Ca
This is the procedure for resetting the windows form the service manual.

Initialization

Follow the steps below after installing each component to the vehicle.

1. Disconnect the minus terminal of battery or disconnect power window switch harness connector temporarily.
Then reconnect after at least 1 minute.

2. Close the door.

3. Turn ignition switch ON.

4. Operate power window switch to make over a half of the window open area.

5. Press the power window switch in the up direction (auto close position) and hold. Continue holding the
switch even when window is completely closed and then release after 3 seconds.

6. Inspect the anti-pinch system function.

NOTE:
Initialization may be cancelled with continuous opening and closing operation. In this case, initialize the system.
Old 02-23-2010 | 06:49 PM
  #7  
JohnEnglish's Avatar
JohnEnglish
Registered Member
 
Joined: Oct 2008
Posts: 1,504
Likes: 2
Originally Posted by csnpsu
When did you buy the car?

Just take it to the dealer
His location says Bergen and according to www.infiniti.eu there's no dealerships in Norway so I'm guessing that's why he wants to avoid taking it to the dealer.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
cellwoot
Body Interior Exterior Lighting
8
09-07-2018 08:10 PM
Raleclair
G's FS
11
10-08-2015 03:06 PM
RexHavoc
Private Classifieds
4
10-02-2015 12:47 PM
CiViCKiDD
Body Interior Exterior Lighting
0
09-24-2015 11:47 AM
Wreckreation
G's FS
1
09-21-2015 07:27 PM




All times are GMT -4. The time now is 10:38 AM.