Review Autokits-X CF front lip and rear diffuser
#25
Registered User
Join Date: May 2009
Location: New York
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Yeah im the only one with that combo.... I been fixing the lip tho yeah had some damage . It should be done by next week.... why dont you Just order the full CF and paint over it to get the carbon splitter look...
#28
Administrator
How much lower does this lip sit guys?
#29
Registered User
Thread Starter
Join Date: Sep 2009
Location: Chesapeake, VA
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for delay guys.
I tried test fit but it is little more difficult than I thought.
I must be doing something wrong because I can't get it right yet.
I am very careful not to scrach my paint so I put some blue painter tape on my bumper.
I will try again soon.
My original bumper is about 7.25 in from ground.
With lip, it is about 6 in. (estimated because it was not fit right yet).
I tried test fit but it is little more difficult than I thought.
I must be doing something wrong because I can't get it right yet.
I am very careful not to scrach my paint so I put some blue painter tape on my bumper.
I will try again soon.
My original bumper is about 7.25 in from ground.
With lip, it is about 6 in. (estimated because it was not fit right yet).
Last edited by 350zrb; 01-17-2010 at 09:25 PM.
#30
Administrator
Thank you very much