Emblems crooked, from factory
#18
Registered User
Thread Starter
Join Date: Jul 2009
Location: Jersey
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
No reason whatsoever to believe there was any body work, etc. Just must have been put on crooked/ dislodged afterward.
#20
Registered User
Thread Starter
Join Date: Jul 2009
Location: Jersey
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
Will most likely remove the I N F I N I T I this weekend, but also considering the following- has anyone moved the mount Fuji logo down closer to the vertical center of the trunk? It looks too high once you remove the letters beneath it.
#21
Registered User
Thread Starter
Join Date: Jul 2009
Location: Jersey
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
The dealer refused to give me the emblems under warranty (free of charge) unless I let them do the install.
When the tech told me that they use a heat gun to remove the old emblems, I just shook my head... the only reason one would do this is to speed up the process. Fishing line & good gone is 100x safer and take at most a few minutes longer. I have serious reservations about these guys replacing my emblems. Not to mention that this service department are absolute a**holes.
When the tech told me that they use a heat gun to remove the old emblems, I just shook my head... the only reason one would do this is to speed up the process. Fishing line & good gone is 100x safer and take at most a few minutes longer. I have serious reservations about these guys replacing my emblems. Not to mention that this service department are absolute a**holes.
#24
Registered User
Thread Starter
Join Date: Jul 2009
Location: Jersey
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
I'm going to write them an email about the **** service department they're running (even aside from this particular incident). The muppets that work there are rude and obnoxious. If they still refuse to accommodate me, I will certainly spread word that their service/parts depts are ****. On the other hand, the salesman is good and I've already recommended him to a friend.
Thread
Thread Starter
Forum
Replies
Last Post
cconklin2
Private Classifieds
7
01-09-2016 07:21 PM
delfinparis
Audio, Video & Electronics
7
10-08-2015 06:06 PM