Review Couldn't get the 5AT to launch, so I took off the VDC/ABS fuse
#1
Administrator
Thread Starter
Couldn't get the 5AT to launch, so I took off the VDC/ABS fuse
Yup, it was starting to annoy me. Everytime I go tracking, the ABS kicks in way more than I need but not only that, it'll also cut fuel at this section where I need to do a 360 around a cone and on top of all, won't allow me to launch or even do a burn out. Of course, switching off VDC only meant it would allow me a little more oversteer but being the crazy Dubian I am, I needed to sort this. So I fiddled around with my engine bay looking for that fuse box and found it. It's located right next to the battery. Took off the clips on the side and off goes the cover. Located the fuse which connected VDC/ABC and some other system that had to do with electronic stability and had it removed!
I switched on the car and holy crap, my dash lit up like Vegas on a Saturday night haha Slip, VDC off and ABS all went on. I started getting excited here! Left foot slightly on the brake, right foot feathering on the gas and BAM!
My nav screen went blank and a message popped up that said: "You Sir, FAIL!"
I switched on the car and holy crap, my dash lit up like Vegas on a Saturday night haha Slip, VDC off and ABS all went on. I started getting excited here! Left foot slightly on the brake, right foot feathering on the gas and BAM!
My nav screen went blank and a message popped up that said: "You Sir, FAIL!"
#5
Administrator
Thread Starter
fuel cut at 3k rpm again lol
Trending Topics
#12
Administrator
Thread Starter
haha well spare it for this one: https://www.myg37.com/forums/picture...on-a-diet.html
Thread
Thread Starter
Forum
Replies
Last Post
Victory
Engine, Drivetrain & Forced-Induction
17
10-27-2022 03:45 PM
CiViCKiDD
Body Interior Exterior Lighting
0
09-24-2015 10:47 AM