Aftermarket Wireless Rear View Camera
#16
Registered Member
Thread Starter
Join Date: Jul 2008
Posts: 1,093
Likes: 0
Received 0 Likes
on
0 Posts
Check the link out, I think i found a solution. The toggle switch is to turn on the NAV display, when you put the car inreverse it will switch the display to backup camera.
https://www.myg37.com/forums/audio-v...version-2.html
https://www.myg37.com/forums/audio-v...version-2.html
#17
Hey guys,
I'm reading the VCI-NIS1 manual and I have some questions.
1. Connecting the power supply wires:
- Connect the VCI-NIS1’s BLACK wire to chassis ground.
- Connect the RED wire to a switched +12 volt source.
Q: Just tape the black wire to the ground? Which +12 Volt Source? cigarette lighter?
2. Wire the VCI-NIS1’s BLUE wire the vehicle’s +12 volt reverse light supply wire. The reverse wire will show +12 volts when the vehicle is put into reverse.
Q: How do I find the reverse signal cable?
3. Wire the VCI-NIS1’s GREEN wire to the vehicle’s negative parking brake supply wire. The parking brake will show continuity to ground when the parking brake is on.
Q: Again how do I find the cable?
Thanks.
I'm reading the VCI-NIS1 manual and I have some questions.
1. Connecting the power supply wires:
- Connect the VCI-NIS1’s BLACK wire to chassis ground.
- Connect the RED wire to a switched +12 volt source.
Q: Just tape the black wire to the ground? Which +12 Volt Source? cigarette lighter?
2. Wire the VCI-NIS1’s BLUE wire the vehicle’s +12 volt reverse light supply wire. The reverse wire will show +12 volts when the vehicle is put into reverse.
Q: How do I find the reverse signal cable?
3. Wire the VCI-NIS1’s GREEN wire to the vehicle’s negative parking brake supply wire. The parking brake will show continuity to ground when the parking brake is on.
Q: Again how do I find the cable?
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Chris Olson
Audio, Video & Electronics
16
03-28-2024 09:46 AM